Address unit for conventional & IS units Salwico NS-AIN1 - «Communication and Radionavigation SPB» Company

NS-AIN1 - addressable device for connecting conventional and IS units, such as smoke, heat or flame detector, analog systems CS3000 fire alarm, CS4000 and NSAC-1. Address device processes the signal and determines the address number and the type of sensor, with which he entered. When the unit / units connected to the NS-AIN1 are in a state of alarm, the red LED on the board lights up. It remains on until the alarm is cleared on the control panel. The included terminating resistor (ELR-33) must be connected after the last block in order to observe the broken cable.

Specifications:

Inputs: one for conventional detector
Input maximum load ~ 5 conv. detectors or 250 mA
System voltage: 24 V DC
Operating voltage: 15 - 35 V DC
Current monitoring ID2 15 mA / ID3 1.5 mA
Alarm ID2 15 mA / ID3 11,5 mA
Termination resistor: ELR-33, 33 ohms
Cable entry: PG16
Cable diameter: 8 - 14 mm
Cable terminals: 2.5 mm2
Working temperature: -25?C to + 70?C
Ambient Humidity: 0 - 95% relative humidity
protection: IP55
Material: PC / ABS
Colour: Grey
Weight ~ 300 g

Available for order

Address unit for conventional & IS units Salwico NS-AIN1

to order

Call our sales manager

Buy

Decoding of NMEA signals (Part 2) This section describes the functionality associated with the reception of data from navigation sensors, supporting the standard IEC 61162-1 or NMEA 0183.